*cutting line( Parting line ) (silicon cutting line): Incision lines of the silicone mold for replication
cutting line( Parting line ) is not removed completely.
The cutting line( Parting line ) is not defective because it is a mark that necessarily occurs during the production process.
*Gate vestiges : Traces of passage for urethane injection.
The Gate vestiges is not defective because it is a mark that necessarily occurs during the production process.
*The dolls are handmade production proceeds.
In the process, dust or air bubbles may enter. If there is a problem with the face part, it will be discarded. However, dust and air bubbles may exist in other areas except the face. This is not a defective product.
* there may be sanding marks caused in the process for gate vestiges, dust, bubble remove or trim.
*After the production of the product, we are working on post-processing using sandpaper.
The process is essential to remove or trim gate vestiges, etc.
In this process, very fine sanding marks are created due to the sandpaper.
This is not a defective product.
*Color difference: it may cause color differences, depending on the production period.
*Drill the inside of the doll body using a drill. (This hole is the passage of the rubber band for assembly.) There may be traces left by the drill in this process.
It is not a defect in the product because it is invisible part in appearance.
*Head masking tape marks:
Inside the eye, other parts, etc. There are masking tape marks on the production process.
Masking tape marks are inside the head. It is not a defect in the product because it is invisible part in appearance.
*The head and the head cap may not fit perfectly without gaps. There may be some gaps.
*Urethane doll's production process has the same characteristics as above.
It is not a defect as a phenomenon occurring in the process.
Therefore, exchange or refund will not be possible.
If you have any questions about the product, please visit the site and leave a message on Q & A.